Carbon FoilMount 3.0
The Carbon FoilMount 3.0 is a compressed carbon plate is not only beautiful it is also incredibly strong allowing it to be thinner than the original FoilMount. This setup weighs just over 1lb so it is also about 30% lighter than previous models. The new curved shape along with it’s light weight and thinner profile make it incredibly low drag in the water. You cannot tell there is a track mounted on the bottom of your board while using it without a hydrofoil. We have also upgraded the included hardware. Because this system is so thin we had to invent a new hardware set that would work with any base plate on the market call the Wizardhat Hardware. Each FoilMount 3.0 Carbon includes a set of 4 Wizardhat hardware and they will allow you to attach any hydrofoil on the market to your FoilMount.
-New Carbon Fiber bulletproof construction
-CNC milled tracks and edges
-Bubble channels in adhesive to decrease bubbles while installing
-Flexible edges and center-line to accommodate more board geometry.
-New more efficient shape
-Lighter design weighs 30% less than FoilMount 2.0
-FoilMount 3.0 Carbon plate with adhesive back
-Installation and preparation materials
-4 sets of Wizardhat hardware
Track spacing: 90mm
Track length: 235mm (9.28in)
FoilMount Weight: 1.2lbs
Advise for mounting:
Preparing the surface: Clean the board surface where you want to place the foil mount with the included alcohol wipes. We recommend using 3M 94 primer for boards with PU coatings for the best adherence.
Choosing the right spot: Make sure you attach to a completely flat area on the board. You will typically ride with your rear foot directly over the mast to slightly behind the mast. Moving the connection point further forward gives you a better ability to pump the board without the nose hitting the water. Making sure to have good grip above the mast for your back foot and 2-3 feet forward for your front foot.