Select Page

4″ Access Port With Lip

$18.00 each

Product Description

4″ Access Port With Lip

Two piece screw-in 4″ Access Port includes one deck ring and one lid. The deck ring is designed to install on a flat surface. The lip accommodates a Cat Bag (sold separately). This hatch is used on the flat locations on forward part of Nacra hull and has been used on Hobies and Prindles as well.  Does not include hardware, hardware options shown in the related items section below.

Flat Access Ports

The underside of port deck rings are flat and are to be used on the specialized flat locations on the decks of various catamarans, such as Hobie Cats, NACRAs, Prindles etc.

Compare to NACRA part number 30943

Fits Boats: Nacra Inter 17, Inter 18, Inter 20, F 18 (NOT F 18 Infusion)

4 inch port specs

Installation suggestions:

To prepare for replacement installation of your 4″ Access Port, remove the old port and clean the contact surfaces. Fill fastener holes if they do not align with the new port.

To prepare for new installation of your 4″ Access Port, cut new hole in the deck for the port. It helps to create a template, by placing the port ring on a piece of paper and tracing the outer ring. Cut out the ring on the outside of the trace line, to ensure that your hole is larger than the port ring. Trace the template onto the desired deck location. Drill a starter hole inside what will be the port, and use a jig saw or other fine control saw to cut through the deck along the trace line.

Apply marine sealant or your other preferred bedding compound to the underside of the ring and the inside edge of the port hole in the deck. With the lid assembled, install the ring into the deck.

Press assembly into position. Press firmly, but keep top surface flat. Remove excess sealant.

Install fasteners (we recommend nylon screws and nuts, because rivets or stainless hardware may exert excess force to distort the shape of the ring, or corrode and make future replacements difficult. (Aluminum rivets with backup washers are OK)

Do not over tighten the fasteners!

Good Luck.

Tags: Deck plate, deck port, port cover, access port

Additional information

Weight 0.25 lbs
Dimensions 5 × 5 × 2 in

White, Black

You may also like…

  • Nut Hex MS #8-32 (White Nylon)

  • Marine Silicone Sealant

    WM Marine Silicone Sealant 3 oz Clear

  • O-Ring for 4″ Screw-In Port

  • Nut Hex MS #8-32 (Stainless Steel)

  • Screw FHMS #8-32 X 1.25 (Nylon)

  • Port Nylon Fastener Kit

  • Washer #8 (White Nylon)

  • Cat Bag 4″

  • Screw FHMS #8-32 X 1 (Stainless Steel)